![]() Click the arrow to flip the Starting offset in the opposite direction.Ĭheck Symmetric to extrude out from both sides of the selected plane. You can set the offset blindly, or from an Entity. Click the arrow to extrude in the opposite direction.Įnter a depth measurement in the dialog, or use the manipulator arrow to add depth to the sketch.Ĭheck Direction and select an axis or Mate connector to specify an extrude direction.Ĭheck Starting offset to move the starting point of the extrude a specific depth from the sketch plane. ![]() ![]() Select the End type: Blind, Up to next, Up to face, Up to part, Up to vertex, or Through all. Select the extrusion result type: New, Add, Remove, or Intersect. Then select the sketch profile in the graphics area. Ensure Solid is selected for the extrude type. To create a solid, first create a sketch profile.Ĭlick the Extrude feature tool on the Part Studio toolbar. Create a new part or surface or modify an existing one by adding or removing material, or intersecting parts in its path. Note: Text can be used as part of a compound profile while extruding.The Extrude feature allows you to add depth to a selected region or planar face along a straight path. Offset: Creates a hole in the extrusion at a distance from the outside of the extrusion equal to the Offset value.įor TC Surface Options, see TC Surface Properties. Enter the angle of deviation from the extrusion path.ĭraft Start / End Distance: If Draft Angle = 0, you can specify a draft angle by entering the offset distances. Available in TurboCAD Pro and Platinum onlyĭraft Angle: Creates an extrusion of increasing or decreasing cross-section. ![]() Solid Options: For these parameters to be accessible, the extrude must be created as a solid. The Properties window of an extrude object contains a Simple Extrude Shape page, in which you can set parameters defining how the object is created.ĭirection: Switch between one-sided and two-sided. Note: Compound profiles can be modified, which updates the 3D objects upon which they are based. If you select nested regions, you can create islands, and regions within islands. Each profile is extruded the same distance. Select the first profile, then press Shift to select additional profiles. Make sure Use Compound Profile is selected. You can also select multiple closed regions, or profiles, to extrude all at one time. If you select, the solid extrusion will be created on either side of the profile. If you select an open profile, the resulting 3D object will be a surface. Move the mouse to extrude the profile, or enter a value in the Height field of the Inspector Bar. Select the 2D open or closed profile to extrude.If necessary, select Finish Selection of Profile to continue.If you want to use a compound profile, which is a series of connected lines and/or arcs, select Use Compound Profile.If you want to select only a simple (single-object) curve, make sure Use Compound Profile is not selected.If you extrude an open profile, a surface will be created. Creates a 3D object by extruding (sweeping) a 2D open or closed profile along a path normal to the workplane of the 2D object.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |